top of page
Forum Posts
James Schofield
Oct 24, 2022
In General Discussions
Well, I have tried to use the Express Cart, I assume it works, I cannot get it to work. In fact with the cartridge as I have it I cannot get it to slot into any machine I have. Be it 800xl or 800 etc.. I am open to suggestions.. if you read the express cart thread, I have tried a bunch of stuff. I cannot run it in the 800xl without the cart around it, for fear of shorting things out, But no matter all the Jiggering I try - and I tried for over 20mins tonight.. I cannot get it to slot in. why? cannot say.. there is really nothing holding the board into the case, so maybe my attempts to get it is cocking it? shifting it? I dont know. On my 800 I put it in without a case.. it will boot but only to a loading config file, and nothing more. SO if anyone wants it. I was trying to support and be involved in the community, but for the amount I use my 8-bit to bbs - this is wAAY too much work. If its pop it in and go.. great.. this is so much frustration.
0
12
76
James Schofield
Oct 07, 2022
0
3
27
James Schofield
Jul 24, 2022
In General Discussions
Hey all I have the ForeSight BBS up and running thesybariteorg.sytes.net:420 Give it a try - if you can - in different translations.. see how things work. I do not think it supports AtascII - but color ASCI and VT52 and I can do RIP and UB something. This is just getting the Software up and running.. I really have done little of any customizing yet. James
2
11
128
James Schofield
Feb 07, 2022
In General Discussions
This is my setup on the Wifi modem. Now FoReM ST has requirements for the modem.dat file. There are also some settings to setup in the Forem.opt - my version.. shown as 2.3 says I can set the speed to HST.. that is the only way it works for me with the UDS-10. and it shows the user connect at 300baud, though it is much faster. Modem.dat says it wants S0=1 (autoanswer) and V(verbose)0 off and I think in the manual it says E=0 as well because you dont want the commands to echo on the sysop screen. Not sure that E makes a difference.. it has not in my attempt to get it working. Where I am at now.. . AMIS says he has had this working with a BONE STOCK install.. SO I am thinking.. go back to the version I downloaded from AMIS - 2.2 its shown as.. and install that.. get it working. THen see if I can move my files over from the 2.3 to the 2.2.. and it would work???4 James
1
38
144
James Schofield
More actions
bottom of page